How to Start a Ford Explorer with a Screwdriver
Starting a Ford Explorer with a screwdriver may seem like an unconventional method, but it can be a lifesaver in situations where the traditional starting methods are not available. Whether you’ve locked your keys in the car or the battery has died, using a screwdriver to start your Ford Explorer can help you get back on the road quickly. In this article, we will guide you through the process of starting a Ford Explorer with a screwdriver.
Step 1: Locate the Starter Motor
The first step is to locate the starter motor in your Ford Explorer. The starter motor is typically located under the hood, near the front of the engine. You can find it by looking for a large, round metal housing with wires connected to it.
Step 2: Remove the Wire Connector
Once you’ve located the starter motor, you’ll need to remove the wire connector. This connector is usually held in place by a bolt or a clamp. Use a screwdriver to remove the bolt or clamp, and then carefully pull the wire connector away from the starter motor.
Step 3: Insert the Screwdriver
Now that the wire connector is removed, insert the screwdriver into the exposed terminal on the starter motor. Make sure the screwdriver is securely in place and that it’s making good contact with the terminal.
Step 4: Connect the Battery
With the screwdriver in place, you’ll need to connect the battery to the starter motor. Locate the negative terminal on the battery and touch the end of the screwdriver to it. Then, touch the other end of the screwdriver to the positive terminal on the starter motor.
Step 5: Start the Engine
Once the battery is connected to the starter motor, you should hear the engine attempt to start. If it doesn’t start, double-check that the screwdriver is making good contact with both the battery and the starter motor terminals. If everything is in place, the engine should turn over and start.
Step 6: Disconnect the Battery
After the engine has started, it’s important to disconnect the battery as soon as possible. This will prevent any damage to the electrical system. Remove the screwdriver from the positive terminal on the starter motor, and then disconnect the battery by removing the wire connector from the negative terminal.
Step 7: Replace the Wire Connector
Finally, replace the wire connector on the starter motor and secure it in place with the bolt or clamp. Make sure the connector is tight and won’t come loose while you’re driving.
Starting a Ford Explorer with a screwdriver is a temporary solution, and it’s important to address the underlying issue that caused the problem in the first place. If you frequently find yourself in situations where you need to start your car with a screwdriver, consider investing in a set of jump leads or a portable battery pack to ensure you’re always prepared for emergencies.
