How to Put 2020 Ford Explorer in 4 Wheel Drive
The 2020 Ford Explorer is a versatile and powerful SUV that offers drivers the option to switch between two-wheel drive (2WD) and four-wheel drive (4WD) as needed. This feature is particularly useful in inclement weather or off-road conditions, where increased traction and stability are essential. In this article, we will guide you through the process of putting your 2020 Ford Explorer in 4WD, ensuring that you are prepared for any driving situation.
Step 1: Park the Vehicle on a Level Surface
Before you begin, make sure your 2020 Ford Explorer is parked on a level surface. This will help ensure that the vehicle is stable and that the transmission can engage properly.
Step 2: Turn Off the Engine
For safety reasons, it is crucial to turn off the engine before attempting to switch the drive mode. This will prevent any unexpected movements or damage to the transmission.
Step 3: Locate the Transfer Case Lever
The transfer case lever is typically located on the driver’s side of the vehicle, near the floor. Look for a lever that resembles a gear or a lever with several positions.
Step 4: Engage 4WD High
To engage 4WD High, move the transfer case lever to the first position from left to right. This position provides the best balance between fuel efficiency and traction in most driving conditions.
Step 5: Engage 4WD Low (Optional)
If you are driving in extreme off-road conditions or need additional traction, you can engage 4WD Low by moving the transfer case lever to the second position from left to right. This position locks the front and rear axles together, providing maximum traction and stability.
Step 6: Start the Engine
Once the transfer case lever is in the desired position, start the engine. The vehicle should now be in 4WD and ready for the conditions you are facing.
Step 7: Monitor the Vehicle’s Performance
After engaging 4WD, keep an eye on the vehicle’s performance. If you notice any unusual behavior or loss of traction, you may need to adjust the transfer case lever or check for any potential issues.
Conclusion
Putting your 2020 Ford Explorer in 4WD is a straightforward process that can be completed in just a few steps. By following the guidelines outlined in this article, you can ensure that your vehicle is equipped to handle a variety of driving conditions. Always remember to consult your vehicle’s owner’s manual for specific instructions and safety precautions. Happy driving!
