How to Manually Start a 2020 Ford Explorer
Starting your 2020 Ford Explorer manually is a straightforward process that can be helpful in situations where the vehicle’s electronic starting system is not functioning properly. Whether you’re dealing with a dead battery or simply want to familiarize yourself with the manual starting procedure, here’s a step-by-step guide to help you get your vehicle up and running.
1. Ensure the Vehicle is in Park
Before attempting to manually start your 2020 Ford Explorer, make sure the vehicle is in park. This is crucial for safety reasons and to prevent the vehicle from rolling while you’re working on it.
2. Locate the Starter Motor
The starter motor is typically located on the front of the engine, near the transmission. It is usually bolted to the engine block and can be identified by its large, round shape and the large wire connected to it.
3. Connect the Battery Cables
If your vehicle’s battery is dead, you’ll need to connect a set of jumper cables to another vehicle’s battery. Make sure the batteries are of similar voltage (12V) and follow these steps:
– Connect the red (positive) cable to the positive terminal of the dead battery.
– Connect the other end of the red cable to the positive terminal of the good battery.
– Connect the black (negative) cable to the negative terminal of the good battery.
– Connect the other end of the black cable to an unpainted metal surface on the engine block of the dead vehicle, away from the battery.
4. Set the Ignition to the “On” Position
With the battery cables connected, turn the ignition to the “On” position. This will allow the engine to attempt to start.
5. Attempt to Start the Engine
With the ignition on, locate the manual starter button, which is typically located on the driver’s side floor console. Press the button to engage the starter motor. You may hear a clicking sound as the engine attempts to turn over. If the engine starts, let it run for a few minutes to charge the battery.
6. Disconnect the Battery Cables
Once the engine is running, turn off the ignition and disconnect the battery cables in the reverse order of how they were connected. Make sure to remove the black cable first, followed by the red cable.
7. Test the Vehicle
After disconnecting the battery cables, test the vehicle to ensure it is operating properly. If the vehicle starts and runs smoothly, you have successfully manually started your 2020 Ford Explorer.
Remember, if your vehicle’s starting system continues to fail, it may be time to have it checked by a professional mechanic. However, following these steps should help you get your 2020 Ford Explorer up and running in most cases.
